General inspekcija komponente (Discovery 3)

All components should be inspected for wear or damage before reassembling.

• Always ensure that component to be inspected is clean and free from oil or grease.
• When a component is to be checked dimensionally against design specified values, use the appropriate measuring equipment i.e. micrometers, verniers, surface plates, dial test indicators (DTI).
• Always ensure that all measuring equipment is correctly calibrated before use.
• Reject a component which is not within specified values/limits or if it appears to be damaged.
• A component may be refitted if dimensions obtained during checking are at the maximum tolerance limit and it is in an undamaged condition.
• Bearing journal clearances should be checked where necessary using Plastigage.

Joints and Joint Faces

All gaskets should be fitted dry unless stated otherwise. Always fit new 'O' rings when reassembling components, always apply the specified lubricant to 'O' rings and fit 'O' rings using the fingers only.

Use gasket removal spray and/or plastic scrapers to remove traces of old gasket.

Izvorna verzija članka na web stranici [www.LRman.ru]

UPOZORENJE: NEMOJTE koristiti metalne strugače ili brusnu krpu jer mogu oštetiti brtvene površine.

Many joints use sealants instead of gaskets as the sealing medium. Where this is the case, the sealant together with its part number will be found listed in the relevant repair operation and also in the sealants table.

PAŽNJA: Uvijek uklonite sve tragove starog brtvila prije ponovnog sastavljanja. Koristite plastične strugače, navedena otapala ako su dostupna ili suhu krpu koja ne ostavlja dlačice. NEMOJTE koristiti metalne strugače ili brusnu krpu jer mogu oštetiti brtvene površine. Osigurajte da površine za brtvljenje budu očišćene od ulja ili masti jer sredstva za brtvljenje neće dobro prianjati na kontaminirane površine.

Do not allow sealant to enter tapped holes or oilways.