Electric winch motor (Defender 2007+)

Removal

NOTE: The removal procedure description may contain installation steps.

1. Refer to the procedure: Disconnecting and connecting the battery (414-01 Battery, Battery Mounting and Cables, General Procedures).

2. Refer to the procedure: Winch (419-12 Winch, Removal and installation).

3. Tightening torque: 7 Nm.



4.


5.

Warnings:

• Mark the position of the cables to facilitate installation.
• To avoid damaging components, use an additional wrench when loosening and tightening terminals.

Tightening torque: 25 Nm.



6.

Warnings:

• If the armature is removed from the motor, the motor brushes will need to be re-adjusted to allow installation.
• Make sure the armature shaft is removed together with the motor housing.
• If necessary, use a suitable tool to move the armature together with the electric motor.

[The original was published on the portal: LRman.ru]




Tightening torque: 8 Nm.

Installation

1. Installation is performed in the reverse order of disassembly.