Car steering Land Rover Defender 90/110/130
Steering Specifications
Steering geometry Steering wheel diameter 412 mm (16,22 in) Front wheel alignment angles Negative toe-in -10' ±10' Rear wheel alignment angles Positive toe-in +5' ±15' Camber - Front Wheels -10' ±45'...
Steering geometry Steering wheel diameter 412 mm (16,22 in) Front wheel alignment angles Negative toe-in -10' ±10' Rear wheel alignment angles Positive toe-in +5' ±15' Camber - Front Wheels -10' ±45'...
Filling and bleeding the power steering system
General procedures 1. Make sure that the working fluid level is at the maximum mark. 2. Warm up the engine to normal operating temperature. 3. Recheck and, if necessary, add working fluid to the...
General procedures 1. Make sure that the working fluid level is at the maximum mark. 2. Warm up the engine to normal operating temperature. 3. Recheck and, if necessary, add working fluid to the...
Power steering system flush
General procedures NOTE: If the steering is difficult or the power steering system is contaminated, the system flushing procedure must be performed as detailed below. If any components have been...
General procedures NOTE: If the steering is difficult or the power steering system is contaminated, the system flushing procedure must be performed as detailed below. If any components have been...
Steering adjustment
General procedures 1. WARNING: Steering gear housing adjustment is not normally required during the warranty period. If a stiff or tight feeling occurs during the warranty period, the unit should be...
General procedures 1. WARNING: Steering gear housing adjustment is not normally required during the warranty period. If a stiff or tight feeling occurs during the warranty period, the unit should be...
Adjusting the steering lock system
General procedures 1. Measure the gap between the tire wall and the longitudinal balancer in the limit position. It should be at least 20 mm. 2. Loosen the stop bolt lock nut. 3. Turn the stop bolt...
General procedures 1. Measure the gap between the tire wall and the longitudinal balancer in the limit position. It should be at least 20 mm. 2. Loosen the stop bolt lock nut. 3. Turn the stop bolt...
Description and operating principle of the steering control
Power steering system Pos. Spare part number Name 1. - Hydraulic pump 2. - Liquid tank 3. - Steering gear housing 4. - Upper section of the column 5. - Cardan joints 6. - Lower shaft 7. - Crimp...
Power steering system Pos. Spare part number Name 1. - Hydraulic pump 2. - Liquid tank 3. - Steering gear housing 4. - Upper section of the column 5. - Cardan joints 6. - Lower shaft 7. - Crimp...
Steering diagnostics and checks
Table of signs of malfunction Incorrect power steering pressure CAUTION: Do not hold the steering wheel at the lock position for more than 30 seconds within a minute to avoid overheating the working...
Table of signs of malfunction Incorrect power steering pressure CAUTION: Do not hold the steering wheel at the lock position for more than 30 seconds within a minute to avoid overheating the working...
Steering gear centering
General procedures 1. Disconnect the longitudinal steering rod of the sector shaft from the steering arm. For more information, refer to the chapter: Connecting arm connected to the sector steering...
General procedures 1. Disconnect the longitudinal steering rod of the sector shaft from the steering arm. For more information, refer to the chapter: Connecting arm connected to the sector steering...
Power steering fluid reservoir
Removal 1. Place a drain pan under the tank. 2. Loosen the support bracket clamp bolt and lift the tank to gain access to the feed and return hose clamps. 3. Release the clamps, disconnect the hoses...
Removal 1. Place a drain pan under the tank. 2. Loosen the support bracket clamp bolt and lift the tank to gain access to the feed and return hose clamps. 3. Release the clamps, disconnect the hoses...
Power steering pump
Removal 1. Disconnect the ground wire from the battery. For more information, refer to the chapter: Disconnecting and connecting the battery (414-01 Battery, Battery Mounting and Cables, General...
Removal 1. Disconnect the ground wire from the battery. For more information, refer to the chapter: Disconnecting and connecting the battery (414-01 Battery, Battery Mounting and Cables, General...
Steering gear
Removal 1. Center the steering wheel. Fix the position, remove the key from the ignition switch. 2. Loosen the upper bolt of the lower steering column shaft. 3. Disconnect the lower steering column...
Removal 1. Center the steering wheel. Fix the position, remove the key from the ignition switch. 2. Loosen the upper bolt of the lower steering column shaft. 3. Disconnect the lower steering column...
Disassembly and assembly of the steering mechanism
Disassembly WARNING: Wear safety glasses when removing and installing the locking wheels and retaining ring. CAUTION: When overhauling the steering gear, absolute cleanliness must be maintained....
Disassembly WARNING: Wear safety glasses when removing and installing the locking wheels and retaining ring. CAUTION: When overhauling the steering gear, absolute cleanliness must be maintained....
Vibration dampener (damper) steering wheel drive
Removal 1. Place the vehicle on a level, horizontal surface and place wheel chocks under the rear wheels. 2. Raise the vehicle and place secure supports underneath it or use a lift. 3. Remove the...
Removal 1. Place the vehicle on a level, horizontal surface and place wheel chocks under the rear wheels. 2. Raise the vehicle and place secure supports underneath it or use a lift. 3. Remove the...
Traction tip
Removal 1. Place the vehicle on a level, horizontal surface and place wheel chocks under the rear wheels. 2. Raise the vehicle and place secure supports underneath it or use a lift. 3. Center the...
Removal 1. Place the vehicle on a level, horizontal surface and place wheel chocks under the rear wheels. 2. Raise the vehicle and place secure supports underneath it or use a lift. 3. Center the...
A connecting lever connected to the sector steering arm lever
Removal 1. Place the vehicle on a level, horizontal surface and place wheel chocks under the rear wheels. 2. Move the wheels to the straight ahead position. 3. Raise the vehicle and place secure...
Removal 1. Place the vehicle on a level, horizontal surface and place wheel chocks under the rear wheels. 2. Move the wheels to the straight ahead position. 3. Raise the vehicle and place secure...
Steering knuckle
Removal 1. Place the vehicle on a level, horizontal surface and place wheel chocks under the rear wheels. 2. Raise the vehicle and place secure supports underneath it or use a lift. 3. Disconnect the...
Removal 1. Place the vehicle on a level, horizontal surface and place wheel chocks under the rear wheels. 2. Raise the vehicle and place secure supports underneath it or use a lift. 3. Disconnect the...
This section is available on russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian
Similar sections from Land Rover repair manuals:
• Chassis: Steering Land Rover Freelander 2 (2006-2014)
• Chassis: Steering Land Rover Discovery 3 (2004-2009)
• Chassis: Steering Land Rover Range Rover 3 (2001-2012)
• Chassis: Steering Land Rover Freelander 2 (2006-2014)
• Chassis: Steering Land Rover Discovery 3 (2004-2009)
• Chassis: Steering Land Rover Range Rover 3 (2001-2012)