Contents: Removal ⇩ Installation ⇩
Removal
1. Open the back door.
2. Remove 2 screws and cover from high brake light.
3. Remove the insulating coating from the connector, release the clamps and disconnect the connectors, being careful not to damage the glass.
4. Unscrew the nuts securing the brake light to the rear window, remove the upper brake light, assemble the seals and washers.
5. Remove the rubber pad, being careful not to damage the frosted glass strip.
Installation
1. Clean the matte strip and install a new rubber pad.
2. Install the high brake light, seals and washers. Install the nuts and tighten them (tightening torque 3 Nm).
3. Insulate the connectors and connect to the rear window.
4. Install the cover onto the high brake light and secure with screws.
Original version of the article on the website LRman.ru
Comments on this article