1. Inspect the running surfaces of the camshaft lobes for pitting or damage. Minor pitting off the work surface is acceptable.
Inspection of the surface of the camshaft (Defender 2007+)
This article is available at russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian
Previous articles
Camshaft lobe lift height
Deformation (warping) of the mating surface of the cylinder block
Deformation (warping) of the mating surface of the cylinder head
Piston pin diameter
Distributor neck diameter
Valve stem diameter
Valve spring free length
The gap in the joint of the piston ring
Clearance between groove and piston
Leak test using exhaust toxicity testing equipment
Axial clearance of the crankshaft
Camshaft axial clearance
Deformation (warping) of the mating surface of the cylinder block
Deformation (warping) of the mating surface of the cylinder head
Piston pin diameter
Distributor neck diameter
Valve stem diameter
Valve spring free length
The gap in the joint of the piston ring
Clearance between groove and piston
Leak test using exhaust toxicity testing equipment
Axial clearance of the crankshaft
Camshaft axial clearance
Current article
Inspection of the surface of the camshaft
Next articles
Similar articles from Land Rover repair manuals:
• General inspection of nodes Freelander 2 (2006-2014)
• Crankshaft — disassembly, inspection and assembly Freelander 1 (1997-2006)
• General inspection of components Discovery 3 (2004-2009)
• Element Inspection Range Rover 3 (2001-2012)
• General inspection of nodes Freelander 2 (2006-2014)
• Crankshaft — disassembly, inspection and assembly Freelander 1 (1997-2006)
• General inspection of components Discovery 3 (2004-2009)
• Element Inspection Range Rover 3 (2001-2012)
No comments yet
Comments on this article