Removing
1.
WARNING: It is forbidden to carry out work on a vehicle supported only by a jack. Be sure to install safety supports under the car.
Raise and support the vehicle.
2. Remove the right rear wheel.
3. Remove a molding of the right back lateral panel. For more information, refer to Rear Side Panel Molding (76.43.55)
4.
NOTE: The illustrations may differ in small details, but the fundamental points are completely true.
Remove the right rear mudguard.
- Remove 2 screws.
- Remove 6 fasteners.
- Disconnect the electrical connector.
5. Disconnect the EVAP canister vent filter from the fuel filler pipe. Cut the collar.
6. Move the EVAP canister vent filter to the side.
7. Disconnect the EVAP canister vent filter from the clip.
8.
NOTE: The illustrations may differ in small details, but the fundamental points are completely true.
Remove the EVAP canister vent filter. Disconnect the canister canister vent filter from the canister canister.
Installation
1. Install the elements in the reverse order of disassembly.
Comments on this article