Elements of the car body Land Rover Discovery 3
Specification
Tightening torque specifications Name Nm lb-ft Engine protection bolts 62 46 Front Fender Mounting Bolts 10 7 Front fender mounting nut 10 7
Tightening torque specifications Name Nm lb-ft Engine protection bolts 62 46 Front Fender Mounting Bolts 10 7 Front fender mounting nut 10 7
Mudguard
Removal 1. CAUTION: Never work on a vehicle supported only by a jack. Always support the vehicle with special stands. Raise the vehicle and place it on supports. 2. Remove the fender molding. For...
Removal 1. CAUTION: Never work on a vehicle supported only by a jack. Always support the vehicle with special stands. Raise the vehicle and place it on supports. 2. Remove the fender molding. For...
Motor protection
Removal 1. CAUTION: Never work on a vehicle supported only by a jack. Always support the vehicle with special stands. Raise and support the vehicle. 2. ATTENTION: Please pay attention to the special...
Removal 1. CAUTION: Never work on a vehicle supported only by a jack. Always support the vehicle with special stands. Raise and support the vehicle. 2. ATTENTION: Please pay attention to the special...
Removal and installation the wing
Removal 1. Disconnect the ground cable from the battery. For more information, refer to Specification. 2. Remove the mixing chamber panel. For more information, refer to Accumulating Chamber...
Removal 1. Disconnect the ground cable from the battery. For more information, refer to Specification. 2. Remove the mixing chamber panel. For more information, refer to Accumulating Chamber...
Lift-up luggage compartment door
Removal 1. Open the rear door and the tailgate. 2. Disconnect the ground cable from the battery. For more information, refer to Specification. 3. Remove the upper tailgate trim panel. Release the 4...
Removal 1. Open the rear door and the tailgate. 2. Disconnect the ground cable from the battery. For more information, refer to Specification. 3. Remove the upper tailgate trim panel. Release the 4...
Alignment of the lifting luggage compartment door
1. With the tailgate closed, check the alignment of the tailgate with the roof panel. The tailgate should be positioned in the center of the opening. The tailgate should be recessed 2 mm beyond the...
1. With the tailgate closed, check the alignment of the tailgate with the roof panel. The tailgate should be positioned in the center of the opening. The tailgate should be recessed 2 mm beyond the...
This section is available on russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian