Passive safety system of the car Land Rover Discovery 1
Location of passive safety system components
1 - Crash (impact) sensor, 2 - Airbag indicator, 3 - Current collector, 4 - Airbag (driver), 5 - Airbag (passenger), 6 - Diagnostic connector, 7 - Airbag control unit, 8 - Wire harness, 9 - Steering...
1 - Crash (impact) sensor, 2 - Airbag indicator, 3 - Current collector, 4 - Airbag (driver), 5 - Airbag (passenger), 6 - Diagnostic connector, 7 - Airbag control unit, 8 - Wire harness, 9 - Steering...
Passive safety system — description
Note: Links to the passive safety system for vehicles produced since 1997: system No. 1: VIN 198222 (distributed) system No. 2: VIN 528977 (simple) Discovery vehicles are equipped with two different...
Note: Links to the passive safety system for vehicles produced since 1997: system No. 1: VIN 198222 (distributed) system No. 2: VIN 528977 (simple) Discovery vehicles are equipped with two different...
Basic instructions
An accident that did not result in the airbag deploying Attention: check the impact area for damage, paying particular attention to the bumper reinforcement, side members, impact dents and the...
An accident that did not result in the airbag deploying Attention: check the impact area for damage, paying particular attention to the bumper reinforcement, side members, impact dents and the...
Towing a car
The airbag didn't deploy Disconnect the battery, first the negative cable, then the positive, turn off the ignition, then tow as usual. The airbag deployed If the airbag deploys, towing should be...
The airbag didn't deploy Disconnect the battery, first the negative cable, then the positive, turn off the ignition, then tow as usual. The airbag deployed If the airbag deploys, towing should be...
Storing the airbag
When temporarily storing the airbag during service work, observe the following rules: Store the pillow with the insert facing up. Store the pillow out of reach of others, on a flat surface, away from...
When temporarily storing the airbag during service work, observe the following rules: Store the pillow with the insert facing up. Store the pillow out of reach of others, on a flat surface, away from...
Testing the shock sensor (distributed safety system)
1. After any collision, check both sensors. Replace the sensor if it is bent, cracked or deformed. 2. Check that the sensor is installed correctly. There should be no gap between the sensor and the...
1. After any collision, check both sensors. Replace the sensor if it is bent, cracked or deformed. 2. Check that the sensor is installed correctly. There should be no gap between the sensor and the...
Security system wiring
1. Do not modify or repair the wiring. Do not place additional equipment wiring (radio, telephone, etc.) next to the security system wiring. Note: Security system wiring is bundled with yellow tape....
1. Do not modify or repair the wiring. Do not place additional equipment wiring (radio, telephone, etc.) next to the security system wiring. Note: Security system wiring is bundled with yellow tape....
Warning stickers
1. Plate under the hood, see the owner's manual included with the vehicle. 2. Current collector. Attention: when removing and installing the current collector, the steered wheels must be in the...
1. Plate under the hood, see the owner's manual included with the vehicle. 2. Current collector. Attention: when removing and installing the current collector, the steered wheels must be in the...
Replacement of the security system
Attention: 1) Remember the route of the wiring harnesses and their attachment points. 2) When replacing system components, connect the component connector before proceeding to the next operation.
Attention: 1) Remember the route of the wiring harnesses and their attachment points. 2) When replacing system components, connect the component connector before proceeding to the next operation.
Airbag (driver)
Removal 1. Turn the steering wheel 90 degrees from the center position. 2. Turn off the ignition. 3. Disconnect the battery (minus first). Disconnect both cables. 4. Release the two access panel...
Removal 1. Turn the steering wheel 90 degrees from the center position. 2. Turn off the ignition. 3. Disconnect the battery (minus first). Disconnect both cables. 4. Release the two access panel...
Steering wheel
1. Remove the airbag. 2. Set the steering wheels to the straight-ahead position. 3. Disconnect the "cruise control" system switch connector from the slip ring (if installed). 4. Release the steering...
1. Remove the airbag. 2. Set the steering wheels to the straight-ahead position. 3. Disconnect the "cruise control" system switch connector from the slip ring (if installed). 4. Release the steering...
Current collector — removal and installation
Attention: 1) When removing and installing the current collector, the steered wheels must be in a straight-ahead position. 2) Store the current collector in a plastic bag. 3) Do not rotate the...
Attention: 1) When removing and installing the current collector, the steered wheels must be in a straight-ahead position. 2) Store the current collector in a plastic bag. 3) Do not rotate the...
Centering the current collector
If the current collector is not centered during installation, the conductive paths may break, which will require replacement of the current collector. Caution: When adjusting the position of the...
If the current collector is not centered during installation, the conductive paths may break, which will require replacement of the current collector. Caution: When adjusting the position of the...
Steering column switch
1. Remove the steering wheel. 2. Rotate the access panel fasteners and remove the panel. 3. Remove the three screws securing the lower steering wheel trim. 4. Remove the steering column covers. 5....
1. Remove the steering wheel. 2. Rotate the access panel fasteners and remove the panel. 3. Remove the three screws securing the lower steering wheel trim. 4. Remove the steering column covers. 5....
Airbag (passenger)
Caution: After an airbag deployment, all system components, including the wiring, must be replaced. 1. Turn off the ignition. 2. Disconnect the battery, first the negative cable, then the positive....
Caution: After an airbag deployment, all system components, including the wiring, must be replaced. 1. Turn off the ignition. 2. Disconnect the battery, first the negative cable, then the positive....
Shock sensor (distributed safety system)
1. Disconnect the battery. 2. Left sensor only: Loosen the power steering pump reservoir clamp and lift the reservoir to access the sensor. Diesel only: Remove the jack and jack mounting bracket. 3....
1. Disconnect the battery. 2. Left sensor only: Loosen the power steering pump reservoir clamp and lift the reservoir to access the sensor. Diesel only: Remove the jack and jack mounting bracket. 3....
Security system control unit (distributed system)
1. Disconnect the battery. 2. Remove the center console, see. " Body ". 3. Unscrew 4 screws and disconnect 2 air ducts to the rear passengers, remove the center console mounting bracket. 4. Using a...
1. Disconnect the battery. 2. Remove the center console, see. " Body ". 3. Unscrew 4 screws and disconnect 2 air ducts to the rear passengers, remove the center console mounting bracket. 4. Using a...
Airbag indicator (SRS)
1. Remove the instrument cluster bezel. 2. Remove the protective glass of the instrument cluster. 3. Unscrew the 3 screws securing the engine control unit to the instrument cluster. 4. Remove the...
1. Remove the instrument cluster bezel. 2. Remove the protective glass of the instrument cluster. 3. Unscrew the 3 screws securing the engine control unit to the instrument cluster. 4. Remove the...
Security system check
1. Remove the driver's airbag. 2. Remove the passenger airbag. 3. Remove the front panel trims. 4. Remove the heater. 5. Remove the cooling unit (air conditioning systems). Models produced before...
1. Remove the driver's airbag. 2. Remove the passenger airbag. 3. Remove the front panel trims. 4. Remove the heater. 5. Remove the cooling unit (air conditioning systems). Models produced before...
Manual airbag deployment
Caution: Explosion on the vehicle may damage the steering wheel. If the airbag does not deploy after an accident, the airbag must be manually deployed. Before detonating the airbag cartridge, check...
Caution: Explosion on the vehicle may damage the steering wheel. If the airbag does not deploy after an accident, the airbag must be manually deployed. Before detonating the airbag cartridge, check...
Security system control unit (simple system)
1. Remove the center console, see. " Body ". 2. Disconnect the control unit connector. 3. Unscrew the 2 mounting screws. 4. Remove the control unit. 5. Installation is carried out in reverse order....
1. Remove the center console, see. " Body ". 2. Disconnect the control unit connector. 3. Unscrew the 2 mounting screws. 4. Remove the control unit. 5. Installation is carried out in reverse order....
Tightening torques for threaded connections (Nm)
Airbag unit screw - 8 Steering wheel nut - 50 Crash sensor screw - 10 Control unit - 10
Airbag unit screw - 8 Steering wheel nut - 50 Crash sensor screw - 10 Control unit - 10
Front seat safety belts
Removal and installation 1. Move the seat forward (5-door models) or fold the seat (3-door models). 2. Remove the decorative cap of the upper belt support mounting bolt. 3. Unscrew the upper belt...
Removal and installation 1. Move the seat forward (5-door models) or fold the seat (3-door models). 2. Remove the decorative cap of the upper belt support mounting bolt. 3. Unscrew the upper belt...
Rear outer seat belts
1. Remove the rear folding seat (if installed). 2. Loosen the speaker mounting screws, disconnect the wires, and remove the speaker. Remove the rear trim panel. 3. Remove the lower luggage...
1. Remove the rear folding seat (if installed). 2. Loosen the speaker mounting screws, disconnect the wires, and remove the speaker. Remove the rear trim panel. 3. Remove the lower luggage...
Rear center seat safety belt
1. Pull both halves of the belt behind the seat back. 2. Fold back the luggage compartment carpet to access the belt support bolts. 3. Loosen the belt support bracket mounting bolts. 4. Remove the...
1. Pull both halves of the belt behind the seat back. 2. Fold back the luggage compartment carpet to access the belt support bolts. 3. Loosen the belt support bracket mounting bolts. 4. Remove the...
Rear folding seat safety belt
1. Remove the folding seat or panel with storage pockets (what is installed). 2. Loosen the speaker mounting screws, disconnect the wires, and remove the speaker. Remove the speaker panel. 3. Remove...
1. Remove the folding seat or panel with storage pockets (what is installed). 2. Loosen the speaker mounting screws, disconnect the wires, and remove the speaker. Remove the speaker panel. 3. Remove...
Rear folding seat safety belt
1. Fold the rear seat. 2. Remove the belt fastening pads. 3. Loosen the belt mounting bolts. 4. Remove the belt. 5. Installation is carried out in reverse order. The tightening torque of the seat...
1. Fold the rear seat. 2. Remove the belt fastening pads. 3. Loosen the belt mounting bolts. 4. Remove the belt. 5. Installation is carried out in reverse order. The tightening torque of the seat...
Front Seat Belts (5-Door 96 Models)
1. Move the seat to access the belt mounting bolts. 2. Remove the decorative caps from the mounting bolts, unscrew the bolt and remove the spacer. 3. For power seats only: Remove the seat side trim...
1. Move the seat to access the belt mounting bolts. 2. Remove the decorative caps from the mounting bolts, unscrew the bolt and remove the spacer. 3. For power seats only: Remove the seat side trim...
This section is available on russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian
Similar sections from Land Rover repair manuals:
• Electrical equipment: Safety system Land Rover Freelander 1 (1997-2006)
• Body and coating: Passenger safety Land Rover Range Rover 3 (2001-2012)
• Electrical equipment: Safety system Land Rover Freelander 1 (1997-2006)
• Body and coating: Passenger safety Land Rover Range Rover 3 (2001-2012)