Engine cooling system (MPi) of vehicle Land Rover Discovery 1

Mpi is a water pump
1. Place a container under the lower pump hose to collect the liquid. 2. Disconnect the hose. 3. Unscrew the 5 pump cover mounting bolts. 4. Remove the cover. 5. Remove the pump impeller. 6. Remove...

Radiator — removal and installation
1. Disconnect the battery. 2. Disconnect the lower radiator hose and drain the coolant. 3. Remove the lower radiator hose. 4. Remove the upper radiator hose. 5. Disconnect the air duct between the...

Temperature sensor
1. Disconnect the sensor wire. 2. Remove the sensor. 3. Clean the sensor threads. 4. Apply Loctite 405 to the sensor threads. 5. Install the sensor in place and tighten to a torque of 15 Nm.

Thermostat — removal and installation
1. Place a container under the upper radiator hose connector to collect the fluid. 2. Disconnect the upper radiator hose from the engine. 3. Release the bypass hose from the clip. 4. Release the...

This section is available on russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

Discovery 3

Discovery 1