Engine starting and battery charging system Discovery 1
Electrical equipment — description
Note: The description of electrical circuits is given in a separate publication. "Manual for troubleshooting electrical equipment" The vehicle wiring is single-wire with the negative pole on the...
Note: The description of electrical circuits is given in a separate publication. "Manual for troubleshooting electrical equipment" The vehicle wiring is single-wire with the negative pole on the...
Generator — Description
Description Three-phase generator with built-in rectifier and electronic voltage regulator. Do not disconnect the battery and/or generator while the engine is running, as this may damage the...
Description Three-phase generator with built-in rectifier and electronic voltage regulator. Do not disconnect the battery and/or generator while the engine is running, as this may damage the...
Anti-theft system
The anti-theft system is only needed to protect against unauthorized opening of doors and hood. The system is controlled by a key that is turned in a specific sequence. The time allotted for opening...
The anti-theft system is only needed to protect against unauthorized opening of doors and hood. The system is controlled by a key that is turned in a specific sequence. The time allotted for opening...
Description of the anti-theft system (model 96)
The anti-theft system provides vehicle protection in accordance with market requirements, i.e., some options described below may vary depending on the model and location of use. Engine start blocking...
The anti-theft system provides vehicle protection in accordance with market requirements, i.e., some options described below may vary depending on the model and location of use. Engine start blocking...
Operation of the anti-theft system (model 96)
Arming the vehicle with a signal from the remote control turns on the engine start inhibit unit and indicates the door locking and activation of the volumetric sensor. Full system activation occurs...
Arming the vehicle with a signal from the remote control turns on the engine start inhibit unit and indicates the door locking and activation of the volumetric sensor. Full system activation occurs...
Checking the anti-theft system (model 96)
Note: To test the door locking system, the remote control must be removed from the ignition key. To check the volume sensor, move the remote control close to the ignition switch. Initial conditions...
Note: To test the door locking system, the remote control must be removed from the ignition key. To check the volume sensor, move the remote control close to the ignition switch. Initial conditions...
Checking the generator
Checking the charging system 1. Check the battery charge level (voltage at the terminals is not less than 12.6 V), charge if necessary. 2. Check the condition of the generator drive belt. 3. Check...
Checking the charging system 1. Check the battery charge level (voltage at the terminals is not less than 12.6 V), charge if necessary. 2. Check the condition of the generator drive belt. 3. Check...
Lucas Constant Energy Ignition System (V8i engine)
Preliminary check Check the condition of the battery terminals and the reliability of the cable connections to them. Check the reliability of the high-voltage wires connection and the absence of a...
Preliminary check Check the condition of the battery terminals and the reliability of the cable connections to them. Check the reliability of the high-voltage wires connection and the absence of a...
Adjustment (ignition timing)
Necessary equipment: precise tachometer stroboscope 1. The ignition timing angle is 6 degrees before TDC. 2. When checking and adjusting the ignition timing, the air conditioning compressor must be...
Necessary equipment: precise tachometer stroboscope 1. The ignition timing angle is 6 degrees before TDC. 2. When checking and adjusting the ignition timing, the air conditioning compressor must be...
Fuse box (in the passenger compartment)
The fuse box is located under the steering column behind the trim panel. The block contains three separate units: A (main block), IN (additional 2) and C (additional 1). The fuse box cover contains...
The fuse box is located under the steering column behind the trim panel. The block contains three separate units: A (main block), IN (additional 2) and C (additional 1). The fuse box cover contains...
Fuse box (in the engine compartment)
The fuse box is located in the engine compartment on the right. The circuits protected and the location of the fuses are indicated on the cover of the unit. To access the fuses, you need to remove...
The fuse box is located in the engine compartment on the right. The circuits protected and the location of the fuses are indicated on the cover of the unit. To access the fuses, you need to remove...
Battery — removal and installation
Some models are equipped with an audible warning signal to alert you when the battery is disconnected. Disconnecting the battery causes an audible signal to sound. To turn off the sound signal: 1....
Some models are equipped with an audible warning signal to alert you when the battery is disconnected. Disconnecting the battery causes an audible signal to sound. To turn off the sound signal: 1....
Electronic ignition of the V8i engine
The ignition system uses a Lucas 35 DLM8 distributor with vacuum and centrifugal ignition timing regulators. When the distributor sensor passes the synchronizing ring protrusion past its core, it...
The ignition system uses a Lucas 35 DLM8 distributor with vacuum and centrifugal ignition timing regulators. When the distributor sensor passes the synchronizing ring protrusion past its core, it...
Ignition coil
1. Disconnect the battery. 2. Mark the wire connection locations and disconnect the wires from the coil. 3. Unscrew the two bolts securing the coil clamp and interference suppressor. 4. Remove the...
1. Disconnect the battery. 2. Mark the wire connection locations and disconnect the wires from the coil. 3. Unscrew the two bolts securing the coil clamp and interference suppressor. 4. Remove the...
Distributor (V8i engine)
Removal 1. Disconnect the battery. 2. Disconnect the vacuum hose. 3. Remove the distributor cap. 4. Disconnect the low voltage wire from the ignition coil. Distributor parts 1 - cover, 2 -...
Removal 1. Disconnect the battery. 2. Disconnect the vacuum hose. 3. Remove the distributor cap. 4. Disconnect the low voltage wire from the ignition coil. Distributor parts 1 - cover, 2 -...
Starter (MPi engine)
1. Disconnect the battery. 2. Unscrew the two nuts securing the traction relay wires and disconnect the wires. 3. Unscrew the three starter mounting bolts. 4. Remove the starter from the flywheel...
1. Disconnect the battery. 2. Unscrew the two nuts securing the traction relay wires and disconnect the wires. 3. Unscrew the three starter mounting bolts. 4. Remove the starter from the flywheel...
Starter (4.0 V8 engine)
1. Disconnect the battery. 2. Raise the car on a lift. 3. Remove the oxygen sensor from the right exhaust pipe. 4. Mark the relative positions of the front propeller shaft and transfer case flanges....
1. Disconnect the battery. 2. Raise the car on a lift. 3. Remove the oxygen sensor from the right exhaust pipe. 4. Mark the relative positions of the front propeller shaft and transfer case flanges....
Starter Thermal Protection (4.0 V8 Engine)
1. Disconnect the battery. 2. Raise the car on a lift. 3. Remove the oxygen sensor from the right exhaust pipe. 4. Loosen the bolt securing the heat shield to the right engine mount. 5. Release the...
1. Disconnect the battery. 2. Raise the car on a lift. 3. Remove the oxygen sensor from the right exhaust pipe. 4. Loosen the bolt securing the heat shield to the right engine mount. 5. Release the...
This section is available on russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian
Similar sections from Land Rover repair manuals:
• Electrical equipment: Starting engine and charging Land Rover Freelander 1 (1997-2006)
• Power unit: Petrol engine V8 Land Rover Range Rover 3 (2001-2012)
• Power unit: Diesel engine ID4 2.4L Land Rover Defender 2007+ (2007-2016)
• Electrical equipment: Starting engine and charging Land Rover Freelander 1 (1997-2006)
• Power unit: Petrol engine V8 Land Rover Range Rover 3 (2001-2012)
• Power unit: Diesel engine ID4 2.4L Land Rover Defender 2007+ (2007-2016)