Exterior car body parts Land Rover Discovery 1

Rear handle
1. Remove the speaker and its panel. 2. Remove the sponge seal. 3. Unscrew the 4 screws securing the handle and remove the handle. 4. Installation is carried out in reverse order.

Wings — removal, painting and installation
Removal 1. Disconnect the battery. 2. Remove the headlight bezel. 3. Remove the front bumper. 4. Remove the turn signal repeater. 5. Unscrew the 4 screws securing the wing to the "A" pillar. 6....

Threshold trim
1. Unscrew the nut and bolt securing the front part of the trim to the wing bracket. 2. Unscrew the screw securing the bracket of the rear part of the trim to the threshold. 3. Using a suitable...

Hood — removal and installation
1. Open the hood and secure it with the stand. 2. Mark the installation position of the hood hinges. 3. With the help of an assistant, unscrew the screws securing the hood hinges, remove the...

Concave air intake panel
1. Remove the wiper arms. 2. Unscrew the nuts securing the brush arm axles, remove the steel and rubber washers. 3. Open the hood. 4. Remove the seal from the concave panel. 5. Disconnect the...

Roof hatch
The hatch can be driven either manually or by an electric motor. In the latter case, the opening of the hatch is controlled by pressing switches mounted on the roof (ceiling of the cabin). Hatch...

Electric sunroof (front and rear)
1. Close the hatch. 2. Disconnect the battery. 3. Remove the ceiling panel. 4. Disconnect the sunroof drive motor connector. 5. Loosen the screws securing the electric motor to the lower frame. 6....

Hatch drive electric motor
Front electric motor 1. Close the hatch. If the sunroof electric motor is faulty, close the sunroof manually by rotating the motor shaft A using a hex key. 2. Disconnect the battery. 3. Remove the...

Sunroof drive control unit
The control unit ensures the operation of both hatches. Mounted above the front sunroof switches behind the ceiling panel. 1. Disconnect the battery. 2. Close the hatch. If the sunroof motor is...

Sunroof, manual control
Removal 1. Close the hatch. 2. Remove the ceiling panel. 3. Loosen the hatch drive mounting screws and remove the drive from the lower frame. 4. Disconnect the drainage channels. 5. Unscrew the 13...

Hatch drive
Front 1. Close the hatch. 2. Loosen the drive handle mounting screw and remove the handle. 3. Remove the switch panel from the interior light panel. 4. Remove the interior light bulb. 5. Remove the...

Sun curtain
Removal 1. Move the hatch to the tilted open position. 2. Remove the decorative trim from the sunroof frame. 3. Release the ceiling panel fasteners to access the lower hatch frame. 4. Bend back the...

Front fender liner
1. Raise the front of the vehicle and place it on stands. 2. Remove the front wheel. 3. Remove the 4 fender liner fasteners. 4. Remove the fender liner 5. Installation is carried out in reverse...

Left rear mudguard
1. Remove the lower luggage compartment trim panel (if rear air conditioning is installed, see below ). 2. Unscrew the 5 bolts and nuts securing the mudguard. 3. Remove the mudguard. 4. Installation...

This section is available on russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

Discovery 3

Discovery 1