Battery and car charging system Land Rover Discovery 3

Battery specification
General specification Name Specification Land Rover Part Number Battery - 4.0 and 4.4 L petrol engines: Voltage Capacity Reserve power 12 75 Ah, 690 A 150 min YGD500030 Battery - 2.7L Diesel Engine:...

Diagnostics and testing of the charging system
General appearance For information on the battery condition indicator, refer to Section 414-01, Battery and Wiring, of the Service Station Manual. When checking and charging the battery, refer to the...

Battery and wires
Item name Spare part catalog number Description 1 - "Positive" battery cable VE 2 - Battery 3 - Clamp 4 - Transit relay 5 - "Negative" battery cable VE General Provisions The battery, mounted in a...

Removal and installation the battery
Removal 1. Secure the hood in the service position. Release the hood struts. 2. Remove the battery cover. 3. Disconnect the ground cable from the battery. For more information, refer to...

Shelf for additional battery
Removal 1. Remove the battery cover. Release the 2 clamps. 2. Disconnect the ground cable from the battery. For more information, refer to Specification. 3. Remove the additional battery, if...

Battery installation shelf
Removal 1. Remove the battery. For more information, refer to Battery (86.15.01) 2. Remove the upper engine compartment heat shield. Remove the screw. Release the 2 clamps. 3. Remove the side wall of...

Generator and voltage regulator specification
General specification Position Specification Generator: Manufacturer/Type Denso SC2 Current strength 90/150 A at 25°C Voltage control Implemented by the power control module (PCM) Regulation of the...

The device and technical description of the generator 4.0L
The generator is mounted on the engine cylinder block, on its right side, in front of the right cylinder head. The generator, manufactured by Denso, has an output current of 85/150 A. A poly V-belt...

The device and technical description of the generator 4.4L
The generator is mounted on the engine cylinder block, on its right side. The generator, manufactured by Denso, has an output current of 85/150 A. A poly V-belt with six grooves is used to drive the...

The device and technical description of the generator 2.7L
The generator is mounted on the engine cylinder block, on its right side, in front of the right cylinder head. The generator, manufactured by Denso, has an output current of 85/150 A. An eight-groove...

Removal and installation the 4.0L generator
Removal 1. Disconnect the ground cable from the battery. For more information, refer to Specification. 2. Remove the accessory drive belt. For more information, refer to Accessory Drive Belt...

Removal and installation the generator 4.4L
Removal 1. CAUTION: Never work on a vehicle supported only by a jack. Always support the vehicle with special stands. Raise and support the vehicle. 2. Disconnect the ground cable from the battery....

Removal and installation a 2.7L generator
Removal 1. Disconnect the ground cable from the battery. For more information, refer to Specification. 2. Remove the cooling fan shroud. For more information, refer to Cooling Fan Shroud (26.25.11)...

This section is available on russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

Discovery 3