Car doors, locks, and windows Land Rover Discovery 1

Front door
Removal 1. Disconnect the battery. 2. Disconnect the door seal at the bottom of the A-pillar. 3. Carefully remove the two floor panel mounting buttons and remove the panel. 4. Disconnect the three...

Front door trim panel
1. Remove the two screws securing the door handle to the bracket on the interior panel. 2. Remove the decorative plug covering the handle cover mounting screw. 3. Loosen the screw and remove the...

Front door glass and window lift
1. Close the window completely, secure the window glass with adhesive tape to prevent the glass from falling. 2. Disconnect the battery. 3. Remove the door trim panel. 4. Remove the plastic seal. 5....

Front door lock and handles
1. Disconnect the battery. 2. Remove the door trim panel. 3. Remove the window glass and window regulator. 4. Remove the door lock drive (see " Electrical equipment of a car "). 5. Disconnect the...

Adjusting the front door lock and handles
Inner handle 1. Before making any adjustments, install the door handle cover and check that the handle is installed correctly. 2. Adjust the length of the synchronous rod by turning the compensator...

Rear side doors
Removal 1. Disconnect the battery. 2. Remove the rubber plug for the wiring from the B-pillar. 3. Pull the wires out of the rack and disconnect the connectors. 4. Unscrew the bolts securing the door...

Rear door trim panel
1. Disconnect the battery. 2. Unscrew the two screws securing the door handle and remove the handle cover. 3. Remove the manual window handle or remove the electric window switch, if installed. 4....

Rear door lock and handles
1. Close the window glass completely. 2. Disconnect the battery. 3. Remove the door trim panel. 4. Remove the plastic door opening seal. 5. Pull the inner handle control rod out of the lock. 6....

Adjusting the rear door lock and handles
1. Disconnect the short connecting rod from the outer handle lever. Adjust the length of the rod by rotating it. Note: The door must be opened until the handle has fully moved.

Rear door glass and window lifter
1. Close the window completely, secure the window glass with adhesive tape to prevent the glass from falling. 2. Disconnect the battery. 3. Remove the door trim panel. 4. Remove the plastic door...

Rear (fifth) door
1. Remove the spare tire from the door. 2. Remove the door trim panel. 3. Remove the rubber plug from the wire harness, pull the wires out of the rack and disconnect the wiring connectors. 4. Remove...

Rear door trim panel
1. Unscrew the two screws securing the door handle and remove the handle. 2. Remove the decorative door handle cover. 3. Place a clip remover between the trim panel and the door, carefully remove the...

Rear door lock and handles
Removal 1. Disconnect the battery. 2. Remove the door handle, trim panel, and plastic door seal. 3. Disconnect the inner handle rod from the lock. 4. Unscrew the 2 screws securing the inner handle...

Rear door safety pillar
1. Remove the rear door from the vehicle. 2. Place the door on a suitable protective material. 3. Unscrew the 2 bolts securing the safety stand. 4. Installation is carried out in reverse order.

Lower luggage compartment trim panels
1. Remove folding seats or side storage bins (what is installed). 2. Disconnect the speaker wires, remove the speaker and the bottom trim panel of the stand. 3. Remove the five trim panel fasteners....

Side windows
1. Loosen the window latch mounting screws and remove the latch cover. 2. Remove the decorative caps from the window hinges. 3. Loosen the screws securing the window glass to the hinges, remove the...

Side window hinges
Removal 1. Remove the window glass. 2. Remove the handle above the window. 3. Disconnect the front seat belt from the mounting post. 4. Remove the pillar panel to access the hinge. 5. Unscrew the...

Rear windows (fixed)
1. Press out the glass, remove the rubber mounting strip. 2. Unscrew the upper rear seat belt fastening. Installation 3. Clean the flange where the rubber glass fastening strip is installed. 4. Clean...

Rear (fifth) door glass
1. Remove the spare tire from the door. 2. Remove the wiper blade and arm. 3. Disconnect the glass heater wires, push out the glass and remove the rubber glass mounting strip. 4. Installation: see...

Windshield
To replace the windshield you will need:. Wire with handles for cutting seals. Glass replacement repair kit. Sealant injection gun. Vacuum glass remover. Note: The adhesive sealant dries for 6-8...

Rear Door Upper Trim Panel (Models with Rear Air Conditioner)
Removal 1. Remove the upper lamp cover panel. 2. Remove the decorative screw caps from the rear door upper panel. 3. Remove the two panel mounting screws. 4. Release the lower part of the panel from...

Window handle
1. Remove the end caps of the trim. 2. Unscrew the 4 screws securing the handle to the body. 3. Remove the handle. 4. Collect the washers. 5. Installation is carried out in reverse order.

Rear door handle (models with rear air conditioning)
1. Remove the decorative trim from the E-pillar. 2. Remove the porous seal from the handle mounting bolts. 3. Unscrew the 4 screws securing the handle. 4. Remove the handle. 5. Installation is...

This section is available on russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

Discovery 3

Discovery 1