2. Remove the door trim panel.
3. Remove the window glass and window regulator.
4. Remove the door lock drive (see "Electrical equipment of a car").
5. Disconnect the door cylinder rod from the latch after removing the metal clip at the bottom of the rod.
6. Disconnect the rod from the outer opening handle (plastic ball joint holder).
7. Disconnect the remote control rod from the lock, after removing the metal clip at the bottom of the rod, remove the rod from the door.
8. Disconnect the synchronous rod from the inner door handle and from the lock. Push one part of the rod into the plastic connector block (access to the unit through a cutout in the inner door panel). The synchronous rod also passes through a guide bracket inside the door.
9. Push the small pin securing the quadrant to the door panel through the cutout in the inner door panel. Pull the quadrant out of the door.
10. Remove the two screws securing the lock to the front of the door and one screw securing it to the inner panel.
11. Remove the lock through the lower rear cutout of the inner panel.
12. Unscrew the two nuts securing the outer door handle bracket (through the lower rear cutout of the inner panel).
13. Carefully remove the door handle from the outer panel.
14. Remove the two screws securing the inner handle to the inner door panel.
15. Remove the handle together with half of the synchronous rod.
16. Disconnect the synchronous rod.
17. Installation is carried out in reverse order.
Comments on this article