Car windshield wipers and washers Land Rover Discovery 1

Cleaners and washers
Component arrangement 1 - switch, 2 - wiper motor, 3 - wiper blade and wiper arm, 4 - washer reservoir, 5 - windshield washer pump, 6 - check valve, 7 - washer nozzle, 8 - rear window washer pump, 9...

Front wiper-washer
The wiper-washer system only operates when the ignition is on. Single brush operation Press the wiper lever down (along arrow A) and let go immediately. Note: When you hold the lever down, the jaw...

Rear wiper-washer
The rear wiper and washer is controlled by buttons located to the right of the instrument cluster. Turning on the rear brush Press the brush switch (button A): after three or four full brush strokes,...

Checking the brush drive motor
1. Check the condition of the brushes. When the rubber blade of the brush wears out, the operating speed of the brushes may decrease and the current in the electric motor winding may increase. Check...

Washer reservoir
1. Unscrew the two upper tank mounting bolts. 2. Unscrew the two lower tank mounting bolts from the wheel arch. 3. Remove the tank and disconnect the pump and injector hoses. 4. Disconnect the wiring...

Washer pump
1. Remove the washer reservoir. 2. Disconnect the pump hoses. 3. Disconnect the pump connectors. 4. Pull the pump out of the tank, remember the position of the seals. 5. Installation is carried out...

Windshield nozzles
1. Disconnect the water supply hose from the nozzle. 2. Unscrew the nut securing the injector to the concave panel and remove the washer. 3. Remove the injector. 4. Installation is carried out in...

Windshield washer hoses
1. Disconnect the hoses from the washer reservoir. 2. Disconnect the hoses from the injectors. 3. Disconnect the hoses from the tee. 4. Release the hoses from the clips and remove the hoses. 5....

Windshield wiper arms
1. Lift the lever cap to access the mounting nut. 2. Unscrew the nut and remove the lever from the drive shaft splines. 3. Turn the brush drive on and off to set the motor to the zero position. 4....

Rear window wiper arm
1. Remove the plastic cap and unscrew the brush arm mounting nut. 2. Remove the lever and spacer from the drive shaft. 3. Turn the brush drive on and off to set the motor to the zero position. 4....

Windshield wipers
1. Move the brush away from the glass. 2. Press the spring clip and remove the brush from the lever hook 3. Installation is carried out in reverse order.

Rear window washer nozzle
1. Turn the nozzle clockwise until it comes out of the body panel. 2. Remove the speaker trim panel. 3. Route the injector hose through the panel. 4. Remove the nozzle from the hose. 5. Installation...

Windshield wiper motor and linkage
1. Disconnect the battery. 2. Remove the brush arms. 3. Unscrew the nuts securing the brush arm drive shafts, remove the steel and rubber washers. 4. Open the hood. 5. Remove the air intake concave...

Rear window wiper motor
1. Disconnect the battery. 2. Remove the rear door trim panel. 3. Remove the spare tire. 4. Remove the brush arm and spacer. 5. Unscrew the drive shaft mounting nut, remove the washer and seal. 6....

Headlight washer nozzle
1. Disconnect the water supply hose from the nozzle. 2. Unscrew the nut securing the nozzle to the bumper. 3. Remove the injector. 4. Installation is carried out in reverse order.

This section is available on russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

Discovery 3

Discovery 1