Steering wheel (Discovery 1)

1. Remove the airbag.

2. Set the steering wheels to the straight-ahead position.



3. Disconnect the "cruise control" system switch connector from the slip ring (if installed).

4. Release the steering column wire harness from the clip.

5. Unscrew the steering wheel mounting nut.

6. Pull the steering wheel off the steering shaft.

7. Pass the wire bundle through the steering wheel hole.

8. Remove the steering wheel.

Caution: Secure the current collector from rotating with adhesive tape.

9. Installation is carried out in reverse order. The tightening torque of the steering wheel nut is 50 Nm.