Mudguard (Discovery 3)

Removal

1.

CAUTION: Never work on a vehicle supported only by a jack. Always support the vehicle with special stands.

Raise the vehicle and place it on supports.

2. Remove the fender molding.

For more information, please refer to Front Fender Trim (76.43.54)

3. Remove the wing splash guard.

• Remove 2 screws.
• Remove 6 holders.
• Disconnect the electrical connector.

4.

NOTE: Do not perform further disassembly if the part is removed only for access.

Remove the tire pressure sensor antenna. Remove the 2 holders.

Installation

1. Install the tire pressure sensor antenna. Install the holders.

2. Install the fender splash guard.

• Connect the electrical connector.
• Install the holders.
• Screw in the screws.

3. Install the fender molding.

For more information, please refer to Front Fender Trim (76.43.54)