Removing
1. Remove the spare wheel.
2.
WARNING: Do not work on or under a vehicle supported only by a jack. Be sure to support the car with special stands.
Raise and support the vehicle.
3. Remove an adsorber of system of catching of steams of fuel.
- Turn out 2 bolts.
- Disconnect 3 lines.
- Disconnect the electrical connector.
4. Remove the fuel tank leak detection module. Remove 3 screws.
Installation
1. Install the fuel tank leak detection module. Screw in the screws.
2. Install the canister for the evaporative emission system.
- Connect the electrical connector.
- Connect highways.
- Tighten the bolts to 23 Nm.
Comments on this article