Removing
1. Remove the spare wheel.
2.
WARNING: Do not work on or under a vehicle supported only by a jack. Be sure to support the car with special stands.
Put the car on a lift.
3. Disconnect the battery ground wire. For more information refer to Specification.
4. Remove the right rear wheel.
5. Remove the wing molding. For more information, refer to Rear Side Panel Molding (76.43.55)
6. Loosen the fuel leak detection filter. Disconnect the breather hose from the fuel leak detection pump.
7. Remove the fuel leak detection filter and breather hose assembly.
- Release the breather hose from the clamp.
- Remove and discard the cable tie.
Installation
1. Install the fuel leak detection filter and breather hose assembly.
- Secure with a cable tie.
- Clamp the breather hose in the clamp.
3. Install the wing molding. For more information, refer to Rear Side Panel Molding (76.43.55)
4. Install the right rear wheel. Tighten the wheel nuts to 140 Nm.
5. Connect a wire of weight of the accumulator. For more information refer to Specification.
6. Install the spare wheel.
Comments on this article