Removing
1. Disconnect the wire "masses" from the battery.
For more information, see the chapter: Disconnecting and connecting the battery (414-01 Battery, Battery Mount and Wires, General Procedures).
2. Remove the floor console.
For more information, see the chapter: Floor Console (501-12 Instrument panel and console, Removal and installation).
3. Remove the mat from the transmission cover panel.
4. Remove the high/low select lever.
5. Release the shift lever.
6. Remove the shift lever. Release two clamps.
7. Release the protective cover of the parking brake lever. Remove 3 clips.
8. Release the parking brake lever.
- 1. Disconnect the electrical connector.
- 2. Turn out two bolts.
9. Remove the transmission cover panel. Remove 11 screws.
10. Remove the steering wheel.
For more information, see chapter: Steering wheel (211-04 Steering column, Removal and installation).
11. Remove the instrument panel.
For more information, see chapter: Instrument panel (413-01 Instrument panel, Removal and installation).
12. Remove the steering column covers.
For more information, see the chapter: Steering column shrouds (501-05 Interior trim, Removal and installation).
13. Disconnect the 2 electrical connectors from the multifunction switch.
14. Disconnect the windshield wiper switch electrical connector.
15. Remove the multifunction switch assembly. Loosen but do not remove the multifunction switch clamp screw.
16. Remove the control panel console.
For more information, refer to the chapter: Dashboard Console (501-12 Instrument panel and console, Removal and installation).
17. Remove the handrail on the passenger side. Remove two screws.
18.
NOTE: Left shield shown, right shield attached the same way.
Remove the decorative elements of the demist deflector on both sides.
19.
NOTE: Left shield shown, right shield attached the same way.
Remove both speakers from the instrument panel.
20.
NOTE: Left shield shown, right shield attached the same way.
Remove both instrument panel speakers. Disconnect the electrical connector.
21. Remove the climate control control panel. Remove 4 screws.
22. Remove the instrument panel. Remove 15 screws.
23.
NOTE: Right side shown, left side similar.
Disconnect the 4 electrical connectors from the instrument panel speakers.
24. With assistance, remove the instrument panel.
Installation
1. With assistance, install the instrument panel.
2. Connect the 4 electrical connectors to the speakers on the instrument panel.
3. Install but do not tighten the instrument panel screws.
4. Tighten the screws in the order shown in the figure.
5. Tighten the screws.
- 1. Tighten (tightening torque 2 Nm).
- 2. Tighten (tightening torque 1 Nm).
6. Attach the climate control control panel. Tighten 4 screws.
7. Install both instrument panel speakers. Connect electrical connectors.
8. Install the demist deflector trims on both sides.
9. Install the handrail on the passenger side. Tighten (tightening torque 7 Nm).
10. Install the control panel console.
For more information, refer to the chapter: Dashboard Console (501-12 Instrument panel and console, Removal and installation).
11. Install the multifunction switch assembly.
- Connect 3 electrical connectors.
- Fully tighten the clamping screw of the multifunction switch.
12. Establish casings of a steering column.
For more information, see the chapter: Steering column shrouds (501-05 Interior trim, Removal and installation).
13. Install the dashboard.
For more information, see chapter: Instrument panel (413-01 Instrument panel, Removal and installation).
14. Install the steering wheel.
For more information, see chapter: Steering wheel (211-04 Steering column, Removal and installation).
15. Install the transmission cover panel. Tighten 11 screws.
16. Fasten the parking brake lever. Tighten (tightening torque 25 Nm).
17. Establish a cover on the parking brake lever. Install 3 clips.
18. Install the shift lever.
19. Fasten the shift lever.
20. Install the high/low select lever.
21. Lay a rug on the panel of a cover of a transmission.
22. Install the floor console.
For more information, see the chapter: Floor Console (501-12 Instrument panel and console, Removal and installation).
23. Connect the wire "masses" to the battery. For more information, see the chapter: Connecting the Battery (414-01 Battery, Battery Mount and Wires, General Procedures).
Comments on this article