Removing
1. Drain the fuel from the tank.
For more information, see the chapter: Emptying the fuel tank (310-00 Fuel supply system - General information, General procedures).
2. Release a collar of fastening of a ventilating hose to a jellied mouth of a tank and remove a hose.
3. Release a collar of fastening of a jellied hose to a jellied mouth of a tank and remove a hose.
4. Turn out the screw and disconnect a wire of weight from a jellied mouth.
5. Remove the sealing sleeve securing the filler neck to the body.
6. Remove the filler neck from the body.
Installation
1. Install the filler neck on the body.
2. Apply soapy water to the rubber grommet.
3. Establish a rubber sealing plug of fastening of a jellied mouth on a body.
4. Connect the ground wire and tighten the screw.
5. Connect the filler hose to the filler neck and tighten the clamp.
6. Connect a vent hose to a jellied mouth and fix a collar.
Comments on this article