Steering column lock and ignition switch housing (Defender 2007+)

Removal

1. Disconnect the ground wire from the battery.

For more information, refer to the chapter: Disconnecting and connecting the battery (414-01 Battery, Battery Mounting and Cables, General Procedures).

2. Remove the control panel.

For more information, please refer to the chapter: Control Panel (501-12 Instrument panel and console, Removal and installation).

3. Disconnect the 4 electrical connectors from the ignition switch.



4. Remove the lower steering column support bracket.

• Using suitable tools, remove and discard the 2 bolts.
• Remove 2 gaskets (between the steering column lock and the lower support bracket).

5. Remove the steering column lock and ignition switch assembly.





6.

NOTE: Do not perform further disassembly if the component is removed only for access.

Remove the ignition switch.

• Remove two screws.

The original article can be found here: LRMAN.RU

Installation

1. Install the elements back in place in reverse order.

• Tighten the bolts until the bolt heads are sheared off.

2. Connect the ground wire to the battery.

For more information, refer to the chapter: Connecting the Battery (414-01 Battery, Battery Mounting and Cables, General Procedures).