Ignition switch (Defender 2007+)

Removal

1. Disconnect the battery ground cable.

For more information, refer to the chapter: Disconnecting and connecting the battery (414-01 Battery, Battery Mounting and Cables, General Procedures).

2. Remove the steering column covers.

For more information, refer to the chapter: Steering Column Covers (501-05 Interior trim, Removal and installation).

3. Remove the instrument panel.

For more information, refer to the chapter: Instrument cluster (413-01 Instrument cluster, Removal and installation).

4. Remove the Passive Anti-Theft System (PATS) transceiver from the ignition switch.



5. Remove the two screws.



6.

CAUTION: Before removing, note the position of the electrical connectors, failure to do so may cause damage to the vehicle.

Disconnect the 4 ignition switch electrical connectors.

Installation

1. Connect the wire harness leads to the ignition switch as they were connected before removal.



2. Install 2 screws.



3. Install the PATS transceiver.



4. Install the instrument panel.



For more information, refer to the chapter: Instrument cluster (413-01 Instrument cluster, Removal and installation).

5. Install the steering column covers.

For more information, refer to the chapter: Steering Column Covers (501-05 Interior trim, Removal and installation).

6. Connect the battery ground wire.

For more information, refer to the chapter: Disconnecting and connecting the battery (414-01 Battery, Battery Mounting and Cables, General Procedures).