Belt/chain tensioner bracket for accessories (Defender 2007+)

Removal

1. Disconnect the ground wire from the battery.

For more information, refer to the chapter: Disconnecting and connecting the battery (414-01 Battery, Battery Mounting and Cables, General Procedures).

2. Remove the accessory drive belt.

For more information, refer to the chapter: Accessory Drive Belt (303-05 Accessory Drive - ID4 2.4L Diesel Engine, Removal and Installation).

3. Remove the engine cover. Unscrew 2 bolts.



4. Remove the engine lift bracket. Remove the 3 bolts.



5.

NOTE: The upper alternator bolt can only be removed when the alternator is disconnected from the accessory drive component bracket.

Release the generator. Remove 3 bolts.





6. Remove the accessory drive element bracket. Unscrew 5 bolts.

Installation

1. Install the accessory drive component bracket. Tighten the 5 bolts (tightening torque 48 Nm).



2.

NOTE: The upper alternator bolt must be installed before installing the alternator to the accessory drive component bracket.

Install the generator. Tighten the 3 bolts (tightening torque 48 Nm).





3. Install the engine lift bracket. Tighten the 3 bolts (tightening torque 10 Nm).



4. Install the engine cover.



5. Install the accessory drive belt.

For more information, refer to the chapter: Accessory Drive Belt (303-05 Accessory Drive - ID4 2.4L Diesel Engine, Removal and Installation).

6. Connect the ground wire to the battery.



The article was copied from this resource: lrman.ru

For more information, refer to the chapter: Connecting the Battery (414-01 Battery, Battery Mounting and Cables, General Procedures).