Removing
1. Disconnect a wire of weight from the storage battery. For more information, refer to Specification
2. Remove the intake manifold. For more information refer to Intake Manifold (30.15.02)
3.
CAUTION: Before disconnecting or dismantling parts, make sure that there is no contamination around the contact surfaces and connections. Close all open connections to avoid contamination of the system.
Remove the left hydraulic timing chain tensioner.
Installation
1. Install the left hydraulic timing chain tensioner.
- Clean the contact surfaces of the parts.
- Tighten the tensioner with a torque of 45 Nm.
3. Connect a wire of weight to the storage battery. For more information, refer to Specification
Comments on this article