Left engine mount (Discovery 3)

Removal

1. Disconnect the ground cable from the battery. For more information, refer to Specification

2.

CAUTION: Never work on or under a vehicle that is supported solely by a jack. Always support the vehicle securely.

Raise and support the vehicle.

3. Remove the left exhaust manifold. For more information, refer to Left Exhaust Manifold (30.15.10)

4. Release the starter wire.

• Remove the terminal cover.
• Remove the terminal nut insulator.
• Unscrew the nut.

5.

CAUTION: When performing this operation, it is necessary to protect the engine.

Remove the engine mount bracket.

• Support the engine.
• Remove 4 bolts.

6. Remove the engine mount. Unscrew and discard the 2 bolts.

Installation

1. Install the engine support.

• Clean the contact surfaces of the parts.
• Tighten the new bolts to 45 Nm and then another 60 degrees.

2. Install the engine mount bracket.

• Clean the contact surfaces of the parts.
• Tighten the bolts (tightening torque 80 Nm).
• Remove the support from under the engine.

3. Connect the starter wire.

• Tighten the nut (tightening torque 10 Nm).
• Install the terminal nut insulator.
• Install the lid.

4. Install the exhaust manifold. For more information, refer to Left Exhaust Manifold (30.15.10)

5. Connect the ground cable to the battery. For more information, refer to Specifications