Electronic video signal modulation unit (Range Rover 3)

Removal

1. Remove the hatch located in the trunk on the left side.



2. Disconnect the 2 connectors from the video signal modulation electronic unit.

3. Mark the location and disconnect the 2 coaxial cables.

4. Unscrew the bolt securing the electronic video signal modulation unit and remove the electronic unit.

Installation

1. Install the video signal modulation electronic unit and tighten the bolt to 10 N·m.

2. Connect the coaxial wires.

3. Connect the wiring connectors.

4. Install the hatch back into place.