Vehicle electronic components Range Rover 3
Trailer Electronic Control Unit
If it is necessary to replace the electronic control unit, then before disconnecting the battery, it is necessary to connect the Testbook / T4 and perform the recommended sequence of actions. Before...
If it is necessary to replace the electronic control unit, then before disconnecting the battery, it is necessary to connect the Testbook / T4 and perform the recommended sequence of actions. Before...
Audio signal relay
Removal 1. Remove the glove box. CAR INTERIOR PARTS, REPAIR WORK, Glove box. 2. Remove the horn relay. Installation 1. Install the horn relay. 2. Install the glove box. CAR INTERIOR PARTS, REPAIR...
Removal 1. Remove the glove box. CAR INTERIOR PARTS, REPAIR WORK, Glove box. 2. Remove the horn relay. Installation 1. Install the horn relay. 2. Install the glove box. CAR INTERIOR PARTS, REPAIR...
Windshield heating relay
Removal 1. Remove the passenger side instrument panel end trim. CAR INTERIOR PARTS, REPAIR WORK, End panel - control panel. 2. Release the relay socket for access by turning it counterclockwise. 3....
Removal 1. Remove the passenger side instrument panel end trim. CAR INTERIOR PARTS, REPAIR WORK, End panel - control panel. 2. Release the relay socket for access by turning it counterclockwise. 3....
Rear window heating relay
Removal 1. Remove the hatch located in the trunk on the right side. 2. Determine which relay needs to be replaced and remove it. Installation 1. Install the relay. 2. Install the hatch back into...
Removal 1. Remove the hatch located in the trunk on the right side. 2. Determine which relay needs to be replaced and remove it. Installation 1. Install the relay. 2. Install the hatch back into...
Body Control Unit (BCU)
If the Body Control Unit (BCU) needs to be replaced, the Testbook/T4 must be connected and the recommended steps must be followed before disconnecting the battery. Before disconnecting the battery,...
If the Body Control Unit (BCU) needs to be replaced, the Testbook/T4 must be connected and the recommended steps must be followed before disconnecting the battery. Before disconnecting the battery,...
Tire Pressure Monitoring System (TPM) Sensor
Removal 1. Raise the vehicle using a jack and place it on stands. WARNING: It is strictly forbidden to work inside or under a vehicle supported only by a lift (jack). In all cases, the vehicle must...
Removal 1. Raise the vehicle using a jack and place it on stands. WARNING: It is strictly forbidden to work inside or under a vehicle supported only by a lift (jack). In all cases, the vehicle must...
Front Wheel Antenna Tire Pressure Monitoring System
Removal 1. Remove the front wheel arch liner. EXTERIOR PARTS, REPAIR WORK, Mudguard - front wheel arch. 2. Disconnect the connector and release the antenna from the mounting brackets. Installation 1....
Removal 1. Remove the front wheel arch liner. EXTERIOR PARTS, REPAIR WORK, Mudguard - front wheel arch. 2. Disconnect the connector and release the antenna from the mounting brackets. Installation 1....
Rear wheel antenna tire air monitoring system
Removal 1. Raise the vehicle using a jack and place it on stands. WARNING: It is strictly forbidden to work inside or under a vehicle supported only by a lift (jack). In all cases, the vehicle must...
Removal 1. Raise the vehicle using a jack and place it on stands. WARNING: It is strictly forbidden to work inside or under a vehicle supported only by a lift (jack). In all cases, the vehicle must...
Electronic control unit of the tire air monitoring system
If it is necessary to replace the electronic control unit, then before disconnecting the battery, it is necessary to connect the Testbook / T4 and perform the recommended actions. Removal 1. Remove...
If it is necessary to replace the electronic control unit, then before disconnecting the battery, it is necessary to connect the Testbook / T4 and perform the recommended actions. Removal 1. Remove...
Electronic control unit parking assistance system
If it is necessary to replace the electronic control unit, then before disconnecting the battery, it is necessary to connect the Testbook / T4 and perform the recommended actions. Before...
If it is necessary to replace the electronic control unit, then before disconnecting the battery, it is necessary to connect the Testbook / T4 and perform the recommended actions. Before...
Rear parking assistance sensor
Removal 1. Release the parking assistance sensor from the rear bumper and disconnect the connector. Remove the sensor. 2. Remove and save the sensor cover. Installation 1. Install the cover on the...
Removal 1. Release the parking assistance sensor from the rear bumper and disconnect the connector. Remove the sensor. 2. Remove and save the sensor cover. Installation 1. Install the cover on the...
Front acoustic speaker for parking assistance system
Removal 1. Remove the panel under the front console. CAR INTERIOR PARTS, REPAIR WORK, Side panel - center console. 2. Unscrew 4 screws and 1 stud securing the panel. 3. Release the panel and...
Removal 1. Remove the panel under the front console. CAR INTERIOR PARTS, REPAIR WORK, Side panel - center console. 2. Unscrew 4 screws and 1 stud securing the panel. 3. Release the panel and...
Rear parking assistance speaker
Removal 1. Remove the hatch located in the trunk on the right side. 2. Disconnect the connector from the speaker. 3. Loosen the speaker mounting nut and remove the speaker. Installation 1. Install...
Removal 1. Remove the hatch located in the trunk on the right side. 2. Disconnect the connector from the speaker. 3. Loosen the speaker mounting nut and remove the speaker. Installation 1. Install...
Interior Front Parking Assist Sensor
Removal 1. Remove the front bumper. 2. Remove the ultrasonic sensor from the bumper, loosen the latches and separate the sensor from the trim. Installation 1. Install the sensor in the trim and mount...
Removal 1. Remove the front bumper. 2. Remove the ultrasonic sensor from the bumper, loosen the latches and separate the sensor from the trim. Installation 1. Install the sensor in the trim and mount...
Front outer parking assistance sensor
Removal 1. Loosen the screw securing the lower part of the bumper to the wheel arch liner. 2. Slightly move the lower edge of the fender liner to the side and release the ultrasonic sensor from the...
Removal 1. Loosen the screw securing the lower part of the bumper to the wheel arch liner. 2. Slightly move the lower edge of the fender liner to the side and release the ultrasonic sensor from the...
Tailgate Motor Electromagnet
Removal 1. Remove the lower trim of the luggage compartment lid. CAR INTERIOR PARTS, REPAIR WORK, Luggage compartment carpet lining. 2. Remove the trunk lid lock. DOORS, REPAIR WORK, External lock -...
Removal 1. Remove the lower trim of the luggage compartment lid. CAR INTERIOR PARTS, REPAIR WORK, Luggage compartment carpet lining. 2. Remove the trunk lid lock. DOORS, REPAIR WORK, External lock -...
Lower side luggage compartment door switch
Removal 1. Remove the lower trim of the luggage compartment lid. DOORS, REPAIR WORK, Upper trim of the lower luggage compartment door. 2. Disconnect the connector from the door lock switch. 3. Loosen...
Removal 1. Remove the lower trim of the luggage compartment lid. DOORS, REPAIR WORK, Upper trim of the lower luggage compartment door. 2. Disconnect the connector from the door lock switch. 3. Loosen...
Sound signal
Removal 1. Raise the front right side of the vehicle and install safety stands. WARNING: It is strictly forbidden to work inside or under a vehicle supported only by a lift (jack). In all cases, the...
Removal 1. Raise the front right side of the vehicle and install safety stands. WARNING: It is strictly forbidden to work inside or under a vehicle supported only by a lift (jack). In all cases, the...
Vehicle tilt Alarm System Sensor
Removal 1. Follow all safety rules when working with the airbag system. GENERAL INFORMATION, Safety precautions when working with the airbag system (SRS). 2. Remove the front passenger seat. SEATS,...
Removal 1. Follow all safety rules when working with the airbag system. GENERAL INFORMATION, Safety precautions when working with the airbag system (SRS). 2. Remove the front passenger seat. SEATS,...
Electronic immobilizer control unit
If it is necessary to replace the electronic control unit, then before disconnecting the battery, it is necessary to connect the Testbook / T4 and perform the recommended actions. Removal 1. Remove...
If it is necessary to replace the electronic control unit, then before disconnecting the battery, it is necessary to connect the Testbook / T4 and perform the recommended actions. Removal 1. Remove...
Hood switch
Removal 1. Disconnect the connector from the hood switch of the security alarm system. 2. Loosen and remove the switch from the engine shield cover. Installation 1. Install the hood switch onto the...
Removal 1. Disconnect the connector from the hood switch of the security alarm system. 2. Loosen and remove the switch from the engine shield cover. Installation 1. Install the hood switch onto the...
Security alarm system receiver
Removal 1. Remove the upper part of the luggage compartment door trim. 2. Remove the Torx bolts securing the receiver to the trunk door. 3. Disconnect the 2 connectors and the antenna wire from the...
Removal 1. Remove the upper part of the luggage compartment door trim. 2. Remove the Torx bolts securing the receiver to the trunk door. 3. Disconnect the 2 connectors and the antenna wire from the...
Volumetric control sensor
Removal 1. Carefully remove the rear ceiling panel console. 2. Disconnect the connector from the interior light. 3. Disconnect the connector from the volumetric control module and remove the console....
Removal 1. Carefully remove the rear ceiling panel console. 2. Disconnect the connector from the interior light. 3. Disconnect the connector from the volumetric control module and remove the console....
Main switch for window lift mode
Removal 1. Remove the driver's side door panel. DOORS, REPAIR WORK, Door panel - front door. 2. Remove the 4 Torx bolts securing the switch assembly to the door panel. 3. Remove the switch block....
Removal 1. Remove the driver's side door panel. DOORS, REPAIR WORK, Door panel - front door. 2. Remove the 4 Torx bolts securing the switch assembly to the door panel. 3. Remove the switch block....
Rear Door Switch Block
Removal 1. Remove the rear door panel. DOORS, REPAIR WORK, Door panel - rear door. 2. Release the 4 latches securing the switch assembly to the door panel. 3. Remove the switch block. Installation 1....
Removal 1. Remove the rear door panel. DOORS, REPAIR WORK, Door panel - rear door. 2. Release the 4 latches securing the switch assembly to the door panel. 3. Remove the switch block. Installation 1....
Instrument panel
Removal 1. Remove the instrument panel cover. CAR INTERIOR PARTS, REPAIR WORK, Upper panel - control panel. 2. Unscrew the 2 screws securing the instrument panel, release the panel from the tabs of...
Removal 1. Remove the instrument panel cover. CAR INTERIOR PARTS, REPAIR WORK, Upper panel - control panel. 2. Unscrew the 2 screws securing the instrument panel, release the panel from the tabs of...
This section is available on russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian