Lighting system and car headlights Range Rover 3

Adjusting the headlight beams
Examination 1. Make sure the vehicle's air suspension is in the standard position. 2. Install and align the headlight adjuster with the headlight. 3. Turn on the headlights. The headlights should be...

Xenon headlight gas discharge control unit
Removal 1. Remove the headlight assembly. LIGHTING, REPAIR WORK, Headlight assembly. 2. Remove the 3 Torx screws securing the control unit to the headlight housing. 3. Disconnect the connector from...

Automatic headlight beam correction control unit
For xenon headlights only. If it is necessary to replace the electronic control unit, then before disconnecting the battery, it is necessary to connect the Testbook / T4 and perform the recommended...

Headlight bulb replacement
WARNING: When servicing vehicles with xenon headlights, the following precautions must be observed. Failure to follow these precautions may result in exposure to ultraviolet rays, serious electric...

Front combination light
Before disconnecting the battery, carefully read the "Disconnecting the Battery" section and follow all instructions therein. GENERAL INFORMATION, Precautions when working with electrical equipment....

Turn signal repeater
Removal 1. Push the turn signal repeater towards the front of the vehicle. Loosen the latches and release the lamp from the fender. 2. Disconnect the connector with the electrical cable. NOTE: If...

Removal and installation the headlight assembly
WARNING: When servicing vehicles with xenon headlights, the following precautions must be observed. Failure to follow these precautions may result in exposure to ultraviolet rays, serious electric...

Rear combination light
Removal 1. Open the upper and lower part of the rear door. 2. Unscrew the 2 screws securing the flashlight to the body. 3. Release the lamp from the fasteners and move it horizontally. Disconnect the...

Reverse light bulb
Removal 1. Loosen the screw securing the reversing light to the bottom of the rear door, release the light and disconnect the bulb holder. 2. Release the lamp from the socket. Installation 1. Install...

Front fog light
Removal 1. Release the clips securing the headlight exterior trim panels to the bumper. Carefully remove and assemble the exterior trim panels. 2. Unscrew the 3 screws securing the light to the...

Brake light central upper
Removal 1. Remove the upper rear door trim. DOORS, REPAIR WORK, Panel trim - upper luggage compartment door. 2. Unscrew the 3 bolts securing the spoiler to the rear door. 3. Disconnect the connector...

Interior lighting lamp front and rear
Removal 1. Release the lampshade from the console, first the top edge. 2. Disconnect the connector and remove the lamp. Installation 1. Place the lamp near the console and attach the connector. 2....

Light switch
Removal 1. Remove the instrument panel end trim. CAR INTERIOR PARTS, REPAIR WORK, End panel - control panel. 2. Remove the deflector that supplies air at the level of the passengers' faces. HEATING...

Hazard warning switch
Removal 1. Loosen the 4 inner latches securing the vent to the trim by applying even pressure until the last latch is released. 2. Disconnect the connector and remove the hazard warning switch....

Combined turn signal/headlight switch
Removal 1. Remove the assembly with moving contacts. RESTRAINT SYSTEMS FOR DRIVER AND PASSENGERS, REPAIR WORK, Rotary current collector. 2. Loosen the 2 latches and disconnect the switch from the...

Lighting Control Module (LCM)
If it is necessary to replace the electronic control unit, then before disconnecting the battery, it is necessary to connect the Testbook / T4 and perform the recommended sequence of actions. Removal...

This section is available on russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

Range Rover 3