Hazard warning switch (Range Rover 3)

Removal

1. Loosen the 4 inner latches securing the vent to the trim by applying even pressure until the last latch is released.

2. Disconnect the connector and remove the hazard warning switch.

Installation

1. Install the hazard warning switch and connect the connector.

2. Install and secure the vent.

This article is available at russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

Article review: Platon Fedorov

Adjusting the headlight beams
Xenon headlight gas discharge control unit
Automatic headlight beam correction control unit
Headlight bulb replacement
Front combination light
Turn signal repeater
Removal and installation the headlight assembly
Rear combination light

Current article

Hazard warning switch

Combined turn signal/headlight switch
Lighting Control Module (LCM)

Comments on this article

No comments yet

Range Rover 3