Electronic control unit of the tire air monitoring system (Range Rover 3)

If it is necessary to replace the electronic control unit, then before disconnecting the battery, it is necessary to connect the Testbook / T4 and perform the recommended actions.

Removal

1. Remove the body control unit (BCU).

ELECTRONIC CONTROL UNITS AND RELAYS, REPAIR WORK, Body Control Unit (BCU).

2. Release the TPMS ECU from the holder, disconnect the connector and remove the ECU.

Installation

1. Position the electronic control unit, connect the connector block and install it into the holder.

2. Install BCU.

ELECTRONIC CONTROL UNITS AND RELAYS, REPAIR WORK, Body Control Unit (BCU).

(Information obtained from the website: lrman.ru)