Removing
1. Remove the fender liner of the front left wheel arch.
EXTERIOR PARTS, REPAIR WORKS, Fender liner - front wheel arch.
2. Install the windshield washer fluid container
3. Disconnect the filler neck from the washer reservoir and destroy the seal.
4. Remembering the installation position, disconnect the block and tubes from the washer pumps.
5. Disconnect the connector from the washer reservoir low level sensor.
6. Disconnect the vent tube from the tank.
7. Turn away 2 bolts of fastening of the tank to a body and release the tank from forward fastening.
8. Remove the washer pumps from the reservoir and destroy the sealant.
Installation
1. Clean the mounting surfaces of the pumps and reservoir.
2. Install new seals on the pumps and install the pumps in the tank.
3. Position the tank on the body, install the bolts and tighten to 3 Nm.
4. Attach the ventilation tube.
5. Connect the block to the low fluid level sensor in the washer reservoir.
6. Attach block and tubes to pumps.
7. Clean the mating surfaces of the filler neck and reservoir.
8. Install the seal on the filler neck and attach to the tank.
9. Fill fluid into reservoir.
10. Install the fender liner.
EXTERIOR PARTS, REPAIR WORKS, Fender liner - front wheel arch.
Comments on this article