Washer fluid reservoir level sensor (Range Rover 3)

Removal

1. Turn the steering wheel to the extreme position.

2. Place the car on a lift.



3. Unscrew the screw securing the lower part of the bumper to the wheel arch liner.



4. Slightly move the lower edge of the fender liner to the side. Remove the fluid level sensor from the reservoir on the inside of the bumper.

5. Disconnect the connector from the fluid level sensor and remove the sensor.

Installation

1. Connect the connector to the liquid level sensor and install the sensor into the tank.

2. Install the wheel arch liner in place and tighten the screws that secure it.

3. Lower the car lift.

4. Set the steering wheel to a position corresponding to straight-line movement of the vehicle.