GENERAL INFORMATION, Precautions when working with electrical equipment.
Removing
1. Disconnect "mass" battery wire.
2. Remembering the installation position, unscrew the nut securing the cleaner lever mechanism and disconnect the mechanism from the electric motor.
3. Remove the 3 bolts securing the mounting plate to the wiper motor.
4. Disconnect block from the electric motor.
5. Remove the electric motor.
Installation
1. Position the motor on the mounting plate, install the bolts and tighten them to 10 Nm.
2. Attach the block to the electric motor.
3. Connect "mass" battery wire.
4. Turn the ignition switch to position II. Switch off the ignition, after making sure that the electric motor is in the park position.
5. Disconnect "mass" battery wire.
6. Attach the linkage to the motor, install the nut and tighten it to 25 Nm.
CAUTION: Make sure the motor is adjusted to the linkage.
7. Connect "mass" battery wire.
Comments on this article