Removing
1. Remove the intake duct.
For more information, refer to the chapter: Air Inlet Pipe (412-01 Air distribution and purification, Removal and installation).
2.
CAUTION: Plug all openings. Use new caps.
Disconnect the expansion tank pipe. Release the clamp.
3. Disconnect the air damper control cable. Release the clamp.
4. Disconnect the fan motor resistor electrical connector.
5. Disconnect the blower motor electrical connector.
6. Remove the blower fan. Loosen 3 nuts.
Installation
1. Replace the elements in reverse order. Tighten (tightening torque 15 Nm).
Comments on this article