English Русский
Български
Беларускі
Український
Српски
Hrvatski
Română
Polski
Slovenský
Magyar

Audio block — removal and installation (Defender 2007+)

Contents: Removal ⇩ Installation ⇩

Removal

1. Using the audio unit removal tools, remove the audio unit.

1. Using the audio unit removal tools, remove the audio unit.

2. Disconnect the 2 electrical connectors from the audio unit.

2. Disconnect the 2 electrical connectors from the audio unit.

3. Remove the audio unit. Disconnect the antenna cable.

3. Remove the audio unit. Disconnect the antenna cable.

Installation

1. Install the elements back in place in reverse order.

This article is available at russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

Article review: Saveliy Ushakov

Previous articles

Navigation system
Sound signal — removal and installation
Watch — removal and installation
Antenna — removal and installation
Audio system — description and principle of operation

Current article

Audio block — removal and installation

Next articles

Acoustic speaker in the rear door
Acoustic column in the control panel
Speaker mounted in a D-rack
Anti-theft system — active
Anti-theft system — passive
Passive Anti-Theft System (PATS) Module
Passive Anti-Theft System (PATS) Receiver

Similar articles from Land Rover repair manuals:
• Audio Amplifier Module (AAM) fault code Freelander 2 (2006-2014)
• Resistor Block — Fan Motor Freelander 1 (1997-2006)
• Receiver valve block Discovery 3 (2004-2009)
• Relay Block (New Evaporative Emission Control System) Discovery 1 (1989-1998)
• Automatic transmission valve block Range Rover 3 (2001-2012)

Comments on this article

No comments yet

We use cookies to make pages load faster and provide a more user-friendly experience 🍪