Processing of closed cavities for injection of the composition (Range Rover 3)

Contents: Front of the body ⇩ Front wing ⇩ Side panel of the body ⇩ Rear wheel arch ⇩ Rear of the body ⇩

Front of the body

The arrows show the injection points of the composition. Welding seams located symmetrically to those shown in the figure are also subject to processing.

Front wing

The arrows show the injection points of the composition. Welding seams located symmetrically to those shown in the figure are also subject to processing.

Side panel of the body

The arrows show the injection points of the composition. Welding seams located symmetrically to those shown in the figure are also subject to processing.

Rear wheel arch

The arrows show the injection points of the composition. Welding seams located symmetrically to those shown in the figure are also subject to processing.

Rear of the body

The arrows show the injection points of the composition. Welding seams located symmetrically to those shown in the figure are also subject to processing.

This article is available at russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

Article review: Platon Fedorov

Types of sealed connections
Body sealing materials
Equipment for applying sealants and primers
Equipment for processing body cavities and processing methods
Applying sealant to the front side members
Applying sealant to the wheel arch and side panel of the body
Applying sealant to the inside of the side panel
Acoustic insulation with foaming material

Current article

Processing of closed cavities for injection of the composition

Cavity filling sealants
Water ingress into the body
Preparing the panel for priming
Preparation for painting

Comments on this article

No comments yet

Range Rover 3