GENERAL INFORMATION, Precautions when working with electrical equipment.
Removing
1. Place the car on a lift.
2. Disconnect "mass" battery wire.
3. Remove the rear driveshaft.
DRIVE SHAFTS, REPAIR WORKS, Cardan shaft - rear.
4. Remove the 8 bolts and 2 nuts securing the right fuel tank guard.
5. Disconnect the 3 hoses from the absorber, unscrew the 2 Torx bolts and remove the absorber.
Installation
1. Install the absorber, fix it with 2 bolts and connect 3 hoses to it.
2. Establish bolts and nuts of fastening of the right protective casing of a fuel tank and tighten them the moment of 25 Нм.
3. Install rear cardan shaft.
DRIVE SHAFTS, REPAIR WORKS, Cardan shaft - rear.
4. Connect "mass" battery wire.
Comments on this article