NOTE: The description of the removal procedure in this manual may include installation steps.
Removing
1. Disconnect a wire of weight from the accumulator. Refer to procedure: Specifications (414-00 Charging system - General information, Specifications).
2. Raise and support the vehicle.
WARNING: It is forbidden to carry out work on a vehicle supported only by a jack. Always place secure supports under the vehicle.
3. Remove the rear wheel. Refer to procedure: Wheel and tire (204-04 Wheels and tires, Removal and installation).
4.
5. Tightening torque: 10 Nm
6. Tightening torque: 10 Nm
Installation
1. When installing, follow the removal procedure in reverse order.
Comments on this article