Sealing of welded seams of the lower part of the car (Range Rover 3)

Welding seams located symmetrically to those shown in the figure are also subject to processing. The drainage holes at the bottom of the doors must not be blocked by sealing material.

[See the source on the website: LRMAN.RU]

This article is available at russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

Article review: Platon Fedorov

Types of sealed connections
Body sealing materials
Equipment for applying sealants and primers
Equipment for processing body cavities and processing methods
Applying sealant to the front side members
Applying sealant to the wheel arch and side panel of the body
Applying sealant to the inside of the side panel
Acoustic insulation with foaming material

Current article

Sealing of welded seams of the lower part of the car

Sealing of door welds
Sealing and materials for the underbody
Processing of closed cavities for injection of the composition
Cavity filling sealants
Water ingress into the body
Preparing the panel for priming
Preparation for painting

Similar articles from Land Rover repair manuals:
• Dimensions of the lower part of the body Freelander 2 (2006-2014)
• Materials for sealing seams Freelander 1 (1997-2006)
• Lower arm bushing Discovery 3 (2004-2009)
• Lower luggage compartment trim panels Discovery 1 (1989-1998)
• Lower arm rear suspension Defender 2007+ (2007-2016)

Comments on this article

No comments yet

Range Rover 3