Front fender panel (Range Rover 3)

Dismantling

1. Unscrew the 9 screws securing the rear part of the mudguard to the inner surface of the wing and to the threshold. Separate the mudguard from the wing to access the fastening elements.



2. Remove the retaining clip securing the lower front fender panel to the lower inner fender.

3. Release the lower panel of the front wing from the clips and remove it.

4. Loosen and remove the threshold seal from the lower panel of the front wing.

NOTE: If disassembly was performed only to provide access to other system components, no further disassembly operations should be performed.

5. Remove the 2 fasteners from the lower panel of the front fender.

Assembly

1. Install the clips on the lower panel of the front fender.

2. Install and secure the sill seal to the lower panel of the front fender.

3. Install the lower panel of the front wing and secure with clips.

4. Secure the front fender lower panel with the lower clip.

5. Install the wheel arch liner in place.