Rear wheel arch liner (Range Rover 3)

Dismantling

1. Raise the rear of the vehicle.

CAUTION: Do not work under a vehicle supported solely by a jack or lift. Always support the vehicle with safety stands.

2. Remove the wheel.



3. Remove the 2 fasteners securing the wheel arch liner to the threshold and bumper.

4. Unscrew the 3 plastic nuts securing the wheel arch liner.

5. Unscrew the 4 hexagon-head screws securing the mudguard.

6. Loosen and remove the wheel arch liner.

The original text was published on the website (lrman.ru)

Assembly

1. Position the fender liner in the wheel arch.

2. Install and tighten the plastic nuts onto the studs.

3. Install and tighten the screws securing the mudguard to the wing and bumper.

4. Install and secure the locking buttons.

5. Replace the wheel and tighten the nuts to a torque of 140 Nm.

6. Remove the supports and lower the vehicle.