Dismantling
1. Remove the rear seat back hinge.
SEATS, REPAIRS, Rear Outboard Seat Hinge.
2. Release the center lock and lower the armrest.
3. Release the tape "Velcro", that secures the armrest trim to the rear of the seatback and fold the trim forward.
4. Remove the Torx screw from the armrest hinge.
5. Separate the armrest assembly from the left hinge tab and remove the armrest.
Assembly
1. Install the armrest assembly onto the hinge tab.
2. Install the Torx screw securing the armrest to the right hinge and tighten the screw to 10 Nm.
3. Stretch the upholstery and fasten the tape "Velcro" on the back of the back.
4. Raise the armrest and secure it to the center bracket.
5. Replace the hinge.
SEATS, REPAIRS, Rear Outboard Seat Hinge.
Comments on this article