Rear seat cushion trim (right side) (Range Rover 3)

Dismantling

1. Remove the seat base cover.

SEATS, REPAIR WORK, Rear seat base panel.

2. Remove the seat folding mechanism.

SEATS, REPAIR WORK, Rear side seat hinge.

3. Disconnect the connector from the wiring harness.

4. Remove the Torx screw that connects the backrest and seat cushion frames. Separate the frames from each other.

5. Release both sides and the front edge of the seat upholstery, lift up the upholstery and cushion.

6. Release the seat heating cable connector from the retainer and route the cable through the frame.

7. Release 1 pin and back trim connecting the upholstery to the cushion frame and remove the upholstery and cushion.

8. Release the 11 staples securing the upholstery to the cushion.

The original text was published on the website LRman.ru

9. Release the 16 rings securing the upholstery to the cushion and remove the upholstery.

Assembly

1. Place the upholstery on the cushion and secure it with rings.

2. Install 11 trim fastening brackets to the bottom of the cushion.

3. Place the cushion on the frame and secure the back edge of the upholstery.

4. Install the rear edge trim fastening pin.

5. Route the seat heating cable through the seat frame and secure the connector block with the clip.

6. Secure the seat upholstery to the sides and front of the seat.

7. Replace the Torx screw securing the backrest frame to the seat frame and tighten to 45 Nm.

8. Connect the connector to the seat back electrical wiring connector.

9. Install the seat folding mechanism.