Lumbar support switch (Range Rover 3)

Before disconnecting the battery, make sure that all requirements and conditions contained in the section on disconnecting the battery are met.

GENERAL INFORMATION, Precautions when working with electrical equipment.

Dismantling

1. Raise the seat cushion.

2. Follow all safety rules when working with passive safety systems.

GENERAL INFORMATION, Safety precautions when working with the airbag system (SRS).

WARNING: Always remove both battery terminals before operating Passive Safety systems (SRS). First disconnect the "negative" terminal. Never mix up the wires when connecting to the battery pack.

3. Remove the screw securing the side panel of the seat base.

4. Release the 3 fastening clips of the side panel of the seat base and carefully separate the panel from the seat.

Models with electric seat adjustments have 4 locks.

5. Disconnect the connector from the lumbar support switch connector.

6. Release and remove the lumbar support switch.

Information obtained from the website LRMAN.ru

Assembly

1. Set the lumbar support switch.

2. Connect the connector to the lumbar support switch connector.



3. Align the side panel of the seat base with the clips and secure it with the screw.

4. Connect the battery terminals, the positive terminal first.

5. Move the seat back to its original position.