Seat adjustment memory switch block (Range Rover 3)

Dismantling

1. Raise the seat.

2. Remove the screw securing the rear end of the seat base side panel.

3. Carefully release the 3 side panel retaining clips.

4. Release the switch block from the 3 clamps.

5. Disconnect the 4 connector blocks and remove the switch block.

Assembly

1. Connect 4 connectors to the switch block connector.

2. Install the switch block on the side panel and secure the 3 fasteners.

3. Install the side panel onto the seat base and secure the 3 clips.

4. Tighten the screw securing the rear part of the side panel.

5. Lower the seat to its original position.