Front seat move switch (Range Rover 3)

Before disconnecting the battery, make sure that all requirements and conditions contained in the section on disconnecting the battery are met.

GENERAL INFORMATION, Precautions when working with electrical equipment.

Dismantling

1. Raise the seat cushion.

2. Follow all safety rules when working with passive safety systems.

GENERAL INFORMATION, Safety precautions when working with the airbag system (SRS).

WARNING: Always remove both battery terminals before operating Passive Safety systems (SRS). First disconnect the "negative" terminal. Never mix up the wires when connecting to the battery pack.

3. Remove the screw securing the side panel of the seat base.

4. Release the 4 fastening clips of the side panel of the seat base and carefully separate the panel from the seat.



5. Release the clips, disconnect the connector blocks and remove the switch block.

Assembly

1. Make sure the lumbar support switch cable is routed correctly.

2. Install the switch block, connect the pads to the connectors and secure the block to the side panel of the seat base.

3. Align the base panel with the clips and secure it with the screw.

4. Connect the battery terminals, the positive terminal first.

5. Move the seat back to its original position.