Adjusting the fit of the sunroof (Range Rover 3)

Examination

1. With the sunroof closed, check the fit of the transparent sunroof panel to the roof panel. The sunroof glass should be in the center of the opening. Deviation from the roof panel in height:

• the front edge of the hatch - flush or lower, up to 1 mm.
• the rear edge of the hatch - flush or higher, up to 1 mm.

Adjustment

1. Open the sunroof sunshade.

2. Press the switch and raise the sunroof fully.



3. Carefully separate the upper edges of the bushings from the sunroof glass.

4. Close the hatch.

5. Loosen the 6 Torx screws securing the sunroof glass.

(The material was taken from a website: lrman.ru)

6. Align the glass flush with the roof and tighten the Torx screws to 6 Nm.

7. Press the switch and raise the sunroof fully.

8. Install the bushings on the sunroof glass.

9. Close the hatch.

10. Close the sunroof sunshade.