General procedures
1. Check the specifications for geometry. Refer to procedure: Specifications (204-00 Suspension - General Information, Specifications).
2. Check the tie rod ends, suspension joints, hub bearings, wheel rims and tires for damage, wear and play.
3. Check and adjust the air pressure in the tires.
4. Place the vehicle on a calibrated horizontal vehicle lift.
5. Release the parking brake.
6. Using only Land Rover approved four-wheel alignment equipment, check and adjust the wheel alignment.
7. Raise the car.
WARNING: Ensure that the vehicle is supported securely.
8. Adjust the rear wheel alignment. Tightening torque: 175 Nm.
9. Re-measure the rear wheel toe.
10. Set the steering wheel to the straight-ahead position.
The article is based on data from the website LRMAN.ru
11. Adjust the front wheel alignment. Tightening torque: 55 Nm.
12. Check the wheel alignment and, if necessary, repeat the adjustment procedure to obtain the required values.
13. Using the Land Rover approved diagnostic system, calibrate the steering angle sensor.
Comments on this article