Checking and adjusting the front wheel alignment angles (Range Rover 3)

Before disconnecting the battery, make sure that all requirements and conditions contained in the section on disconnecting the battery are met.

GENERAL INFORMATION, Precautions when working with electrical equipment.

Checking wheel alignment angles

1. Make sure that the tire pressure is normal and the vehicle body height is normal.

2. Roll the vehicle back and forth to relieve stress in the suspension and steering components.

3. Make sure the wheel alignment equipment is properly calibrated.

Note: Use only the four-wheel angle adjustment equipment recommended by Land Rover.

The original text was published on the website www.LRman.ru

4. Check and, if necessary, adjust the front wheel alignment.

Adjustment

1. Disconnect the negative terminal from the battery.

2. Mark the position of each tie rod end relative to the tie rod.

3. Loosen the locknuts securing the ends of the steering rods.

4. Adjust the wheel alignment by turning each steering rod, acting on the steering rod hexagon. Do not allow the tip body to turn or the protective cover to tighten.

CAUTION: The right and left steering rods must turn at the same angles.

5. Check the front wheel alignment again.

6. Tighten the steering rod locknuts to a tightening torque of 55 N·m.

7. Connect the negative terminal to the battery.